Firmware · 19-01-2026
LAN module for RFX-433EMC and RFX-868
The W5500 LAN module can be used on the RFX-433EMC or RFX-868 using the RFXCOM protocol or MQTT. The option is connected to the RFX with a Push-To-Fit connector and can be soldered for a more reliable connection. Open the enclosure. Insert the Push-To-Fit pins on the component side in the PCB. Check…
The W5500 LAN module can be used on the RFX-433EMC or RFX-868 using the RFXCOM protocol or MQTT.
The option is connected to the RFX with a Push-To-Fit connector and can be soldered for a more reliable connection.
- Open the enclosure.
- Insert the Push-To-Fit pins on the component side in the PCB. Check that the 2 pins are inserted at 3V3 and GND
- Insert the PCB in the top of the enclosure.
- Hold the bottom part on it and mark the points where the connection PCB is.
- Make a 3.5mm deep recess in the bottom part so that the enclosure can be closed.
- Flash the LAN software.