RFXCOM PLUG-IN POSSIBILITIES


RECEIVING
Connect up to 8 RFXCOM receiver interfaces (is 8 to 16 receivers)
Configuration options for the protocols to be used in the receiver
Receive X10 sensors & remotes
Receive Visonic and SecureLinc sensors & remotes
Receive KlikAan-KlikUit, ELRO AB600 motion sensors & remotes
Receive BBSB, Proove, NEXA, DomiaLite motion sensors & remotes
Receive HomeEasy heater commands, motion sensors & remotes
Receive ATI Remote Wonder
Receive Electrisave/Cent-a-meter/OWL CM113
Receive OWL CM119
Receive Digimax (with heat & cool status)
Receive Oregon Scientific sensors
Receive Oregon Body Weight Scale
Receive RFXSensor (temperature, humidity and barometric sensors)
Receive RFXPower
Receive RFXMeter (whole house power, gas and water usage metering)
Redirect X10 lighting sensor & remote house codes to another house code
Disable/Enable received X10 lighting sensor & remote house codes
Configure RFXCharts parameters to be used for each Input Sensor
Configure the suffix to be used for each Input Sensor
Configure the Calibration value to be used for each Input Sensor
Configure a Divide By for each Input Sensor
Configure to use an icon for each Input Sensor
Configure High-Low Alarm and Warning levels for each Input Sensor
Automatically hide battery status for Input Sensors if battery level is OK
Selection to display values in Metric or US format
Selection to use On/Off or numeric values for HomeEasy and KlikAanKlikUit

VIRTUAL SENSORS
Daily sensors for Power Usage, Water Usage, Gas Usage, Total Rain Fall
Instant Usage sensors for Power, Water, Gas
High/Low sensors for Temperature, Humidity
High sensors for Wind Speed, Rain Rate
Barometer sensor with height corrections
Heat Index sensor
Wind Chill sensor
Dew Point sensor

SENSOR PANEL
Sensor Panel Messages device with trigger function

SECURITY PANEL
Alarm Panel Messages device with trigger function
Alarm Panel State device with trigger function
Alarm Panel Status device with trigger function
Alarm Panel Control device with trigger function and Arm/Disarm buttons
Alarm Unlock Panel (very useful with HSTouch)
Set delay time for the security system and sensors
Disable security sensor for use in Arm-Home
Connect/disconnect a security sensor in the security system
Enable/Disable Security sensors (to disable a sensor temporarily if sensor error)
Synchronize an X10 Security Panel (SC9000) using the RFXCOM transmitter

TRANSMITTER
Connect up to 4 RFXCOM transmitters
Configure protocols to be used in the transmitter
Control X10 lighting modules & security panels
Control ELRO AB600
Control BBSB, Proove, NEXA, DomiaLite, Intertechno, Düwi,
Control KlikAan-KlikUit (including Automatic Code)
Control Harrison electrical curtains
Control HomeEasy (including Automatic Code)
Control HomeEasy heater
Configure a secure code used for HomeEasy and KlikAanKlikUit Automatic Code devices

CHARTING OPTIONS
Supported by RFXCHARTS (no need to use the example charts)
Example charts with source for Digimax
Example charts with source for Oregon Scientific sensors
Example charts with source for Oregon Body Weight Scale
Example charts with source for RFXSensor (temp,humidity,baro)
Example charts with source for RFXPower, RFXMeter (power,gas,water)

DOCUMENTATION
Detailed Plug-in & Charts documentation