Documentation:

Quick Start Guides:

Quick_Start_Girder.pdf V0.0

Quick_Start_Homeseer.pdf V2.2

Quick_Start_Indigo.pdf V0.1

Quick_Start_MisterHouse.pdf V0.0

Quick_Start_PowerHome.pdf V0.0

Quick_Start_xPL.pdf V0.0

Quick_Start_xPL-Perl.pdf V0.0

Quick_Start_Xtension.pdf V0.1

xAP Homeseer.pdf  (full document) V0.0

Harrison Config V1.0

 

Interface modules:

RFXCOM USB module, V2.1

Handshake installation, V2.0

RFXCOM Ethernet Interface, V4.0

RFXCOM Ethernet Interface, V4.0

 

Receivers/Récepteurs:

RFXCOM Visonic codes receiver, V88.1

RFXCOM RF receivers, V19.2 

RFXCOM Récepteurs RF V19.2

 

Transmitters/Transmetteurs:

RFXCOM RF transmitters, V14.2

RFXCOM Transmetteurs RF, V14.2

 

Sensors:

RFXSensor RF transmitter for 1-Wire sensors. V11.0, 

RFXSensor Transmetteurs RF pour sondes 1-Wire. V11.0, 

RFXMeter RF transmitter for metering devices. V3.0

RFXMeter Transmetteur RF pour la mesure. V3.0
RFXPwr electrical power usage metering module. V2.0

RFXPwr pour la mesure de consommation électrique. V2.0  
RFXPulse optical or switch pulse metering module. V
4.0

RFXPulse mesurer les pulsations. V3.0  

 

 

Software:

 

Test and configuration software:

Programs to test and configure the receiver and the transmitter can be downloaded here for free:

Click on the link and select "Save" to download the program to your system.

Program for the receiver (version 31.0.0.5) :     RFreceiver
Program for the transmitter (version 18.0) :      RFtransmitter
Program for the RFXmitter (version 4.1) :         RFXmitter

USB driver software:

The latest versions of the RFXCOM USB module use an FTDI FT232 interface IC.
The VCP Virtual Com Port driver can be downloaded from this site: http://www.ftdichip.com/Drivers/VCP.htm

Script for Indigo:
This script reads RFXSensor data into Indigo RFXSensor_Indigo.zip (with thanks to flic)

RFXCOM Homeseer plug-in:

Homeseer plug-in for RFXCOM receivers and transmitters with USB, LAN or WLAN interface.
Control and receive information from local and remote locations.
Remote locations can be connected via the Internet by using the LAN or WLAN interface

Environmental sensors can be configured for the use on chart web pages.
The plug-in is available in the Homeseer updater.
Documentation is in the Homeseer 2\Docs directory:
Plug-in & charts documentation:
     hspi_RFXCOM.pdf V13.4
     hspi_RFXCOM_FR.pdf V5.1
 
     RFXCOM_charts.pdf V9.1
     RFXCOM_charts_FR.pdf V8.0
 

Plug-in requirements:
- The plug-in needs Homeseer version 2.2.0.66 or higher.
For best performance the following versions are advised:
- 310MHz receiver: version 35 or up,
- 433.92MHz X10 receiver: version 29 or up,
- Receivers for Visonic sensors: version 8F or up.
- All transmitters versions are supported.

               

                                           Click on the pictures to enlarge.