Description of the 433.92MHz  RFXCOM Visonic receiver:

This receiver is able to receive:

• Visonic sensors using the PowerCode format.

• Visonic keyfobs using the CodeSecure format.

The USB/LAN/WLAN receiver set contains a master receiver and a connector for an optional slave receiver.

The function of the master is to control the communication on the communication interface. If the slave receiver needs the communication interface to transmit data, it will send a request to the master and the master will allow the slave to transmit the received data on the communication interface at the time that the master doesn't need the communication interface. By this mechanism the data of the receivers is never transmitted on the communication interface at the same time and no data is disturbed.

For more information see the receiver documentation at the download page.

For the list of supported by software click here.

Capabilities of this receiver:

• Receiver sensitivity of -106dBm with SAW filter input.

• Receive and decode Visonic sensors and remotes.

• Receive in RAW mode.

• 2 receivers on 1 interface. (1 Master and 1 Slave)

• Handshake signal to allow a RF transmitter to transmit on the same frequency.

• Software selectable decoding and output:

  32 bits, Visonic data translated to X10 codes,

  32 bit direct, Visonic data translated to X10 codes (W800 compatible mode)

  variable length mode with number of bits received. Visonic data is translated to X10 codes

  up to 96 bits Visonic data with number of bits received

  RAW mode - displays pulse timing.

• The RS232 data format is 4800bd, 8 bits data, no parity, 1 stop bit
  or 38400bd. (software selectable)

Important remark:

The software version of an X10 receiver installed in the same USB interface needs to be version 9 or higher.

DIY extension possibilities:

There are connection possibilities for a pushbutton switch and a relay.
When the pushbutton input is low, the device address of a received Visonic command is saved. A received On-Off command for this device address will switch the Relay output.

Firmware revision history:

Note: to know your receiver version, use RFreceiver and push the "Get receiver version" button.

Version 80

• production version

Version 81

• Panic code changed from 0x22 to 0x26

• in X10 mode the motion sensor codes are xmitted if bit 7 is off otherwise door sensor codes are xmitted

Version 82

• erase aux contact in EEPROM cmd 0xF042 added

• alive xmitted for auxiliary contact in x10 modes

• repeated packets not xmitted in x10 modes

Version 83 and 84

• Firmware improvements

Version 85

• in 32 bits mode the address is like the X10 security standard and 3 repeats

• mode 48 bits deleted

Version 86

• keyfob address changed in 32 bit

Version 87

• jamming detect changed from 16ms to 3.2sec

• 32 bit X10 mode deleted

Version 88

• jamming detect changed from 3.2sec to 96ms

Version 89

• Internal release

Version 8A

• 5 seconds timeout for receiving auxiliary contact data corrected (used in X10 modes only)

• keyfob receiving a little bit optimized.

Version 8B

• if KAKU or Koppla mode is set then stop Visonic receiver

• ACK send if KAKU, Koppla or Visonic cmd received by Master receiver

• Version Request also responds if receiver not active.

Version 8C

• Support for RFXCOM Homeseer plug-in

• Disable Visonic receiver command added

Version 8D, 8E

• Internal release

Version 8F

• Master/Slave sync problem solved

• signal decoding hardware changed